Módulo transceptor SFP28 BlueOptics SFP28-25G-ERL-30-SP-BO 25000 Mbit/s

The BlueOptics SFP28-25G-ERL-30-SP-BO is a fiber optic transceiver module designed for high-speed serial data transmission over single-mode fiber. Compatible with SFP28 ports, this module supports a maximum data rate of 25,000 Mbit/s and is intended for use in environments where reliable, long-reach connectivity is required. The compact SFP28 form factor allows straightforward installation in switches, routers and network interface cards that accept SFP28 modules.

Advantages

This transceiver offers a clear technical specification focused on throughput and form-factor compatibility: SFP28 interface support and a 25 Gbit/s maximum transfer rate. The module's design suits single-mode fiber links that require extended reach, providing consistent optical communication with standards-based electrical and optical signalling. Its small size and standardized plug-and-play form factor simplify inventory and deployment in mixed-vendor environments.

Suitable for

• 25 Gbit/s uplinks between switches and aggregation devices
• High-speed server connections in data centers
• Enterprise backbone links requiring single-mode fiber
• Network equipment with SFP28 ports for fiber connectivity

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25,000 Mbit/s
• Optical medium: single-mode fiber (SMF)
• Form factor: SFP28 compact transceiver
• Typical applications: 25 Gbit/s Ethernet and high-speed serial links

How to use

Install the BlueOptics SFP28 module into a compatible SFP28 slot on your switch, router or network card while the host device is powered down or following the manufacturer's hot-swap guidelines. Connect appropriate single-mode fiber patch cables and verify link status through the host device's management interface. Configure the port for the expected speed and protocol (for example, 25 Gigabit Ethernet) and confirm optical parameters such as link distance and power budget match your network design.

Recommendations

Use single-mode fiber patch cords with appropriate connector types and maintain clean connector endfaces to ensure optimal optical performance. Verify compatibility with the host device's SFP28 port firmware and monitor temperature and signal diagnostics where supported to maintain reliable 25 Gbit/s operation.