Módulo transceptor XFP BlueOptics 444689-001-BO 10000 Mbit/s

The BlueOptics 444689-001-BO XFP transceiver module provides a compact, hot-pluggable interface for 10 Gbit/s optical links. Designed for use in networking equipment that supports the XFP form factor, this silver-coloured module supports a maximum data transfer rate of 10000 Mbit/s. The unit is lightweight at 20 g and meets CE, FCC and RoHS compliance, with a specified mean time between failures (MTBF) of 1,000,000 hours to support reliable operation in data centre and enterprise environments.

Advantages

The module offers a standard XFP form factor for broad compatibility with switches, routers and optical transponders that accept XFP modules. Its maximum data transfer rate of 10000 Mbit/s suits high-throughput applications while the compact, hot-swappable design simplifies installation and replacement without disrupting connected systems. Compliance with CE, FCC and RoHS ensures the module meets common regulatory and environmental requirements.

Suitable for

• 10 Gbit/s fiber optic uplinks and backbone connections
• Network switches, routers and optical transponders with XFP slots
• Data centre aggregation and core links
• Enterprise WAN and metro network segments

Key specifications

• Interface type: XFP
• Maximum data transfer rate: 10000 Mbit/s
• Form factor: XFP transceiver module
• Product colour: Silver
• Weight: 0.02 kg
• MTBF: 1,000,000 hours
• Compliance: CE, FCC, RoHS

How to use

Install the BlueOptics XFP transceiver into a compatible XFP port on a switch, router or transponder following the equipment manufacturer’s hot-swap procedures. Ensure the module is fully seated and latched before connecting fiber optic cables. Observe proper electrostatic discharge (ESD) precautions during handling and keep protective caps on the optical interface when the module is not connected to prevent contamination. Verify link status and configuration on the host device after insertion.

Recommendations

Use multimode or single-mode fiber and appropriate connectors as required by the host equipment and network design. Maintain clean fiber end faces and perform testing after installation to confirm expected throughput and link stability. Store unused modules in protective packaging and avoid exposure to excessive humidity, dust or mechanical shock.