Módulo transceptor XFP BlueOptics XFP-10GE-M 10000 Mbit/s 850 nm

The BlueOptics XFP-10GE-M is an XFP transceiver module engineered for 10 Gigabit Ethernet links over multimode fiber using an 850 nm wavelength. Housed in a compact silver module and weighing approximately 20 g, this single-unit transceiver supports data throughput up to 10000 Mbit/s and fits standard XFP ports for use in switches, routers and media converters. The product is intended for installations where consistent high-speed optical connectivity and compatibility with XFP interfaces are required.

Advantages

The module provides stable 10 Gbit/s performance with an industry-standard XFP interface and a short-wavelength 850 nm optical design suitable for multimode links. Its compact silver enclosure and light weight simplify installation and reduce port area occupation. As a single-unit packaged transceiver, it offers straightforward replacement and upgrade paths for network equipment supporting XFP optics.

Suitable for

Key specifications

How to use

Install the BlueOptics XFP-10GE-M by inserting it into an XFP-compatible port on network equipment while the device is powered down or following hot-swap guidelines provided by the equipment manufacturer. Connect the appropriate multimode fiber patch cable to the transceiver optical interface, verify link status through the host device management interface, and monitor optical and link indicators to confirm proper operation. For safe handling, avoid touching the optical connector endfaces and keep protective dust caps in place when the module is not connected.

Recommendations

Use this transceiver with multimode fiber cables and connectors rated for 850 nm operation, maintain clean connector endfaces, and ensure the host device firmware supports XFP optics. Follow manufacturer guidelines for maximum supported reach and temperature ranges; when replacing modules, match interface and wavelength specifications to avoid link issues.