Transceptor SFP CBO SFP-1G-MMF-2KM para fibra multimodo de 1 Gbit/s, alcance 2 km

CBO SFP-1G-MMF-2KM for 1 Gbps multimode fiber, 2 km reach is an SFP optical transceiver module designed to establish 1 Gbps links over multimode fiber. The module supports standard SFP form-factor interfaces and is intended for short- to medium-range connections up to 2 km in enterprise LANs, data centers and campus networks. It enables fiber uplinks between switches, routers and other network equipment using multimode fiber cabling.

Advantages

The transceiver provides a compact SFP footprint compatible with common networking devices and supports 1 Gbps data throughput over multimode fiber for predictable performance. Its plug-and-play design simplifies installation and replacement in SFP ports without special tools. The module is suitable for environments where reliable multimode fiber connectivity and straightforward interoperability are required.

Suitable for

• Switch-to-switch and switch-to-router fiber uplinks within buildings
• Data center rack-to-rack multimode connections
• Campus LAN segments and inter-building links over multimode cabling
• Network equipment upgrades where SFP 1 Gbps multimode modules are required

Key specifications

• Interface: Small Form-factor Pluggable (SFP)
• Data rate: 1 Gbps (Gigabit Ethernet compatible)
• Fiber type: Multimode fiber (MMF)
• Nominal reach: up to 2 km over appropriate multimode fiber
• Connector: Duplex LC
• Wavelength: multimode-appropriate optical wavelength (industry standard)
• Power and temperature: designed for standard networking equipment operating conditions

How to use

Insert the SFP module into an empty SFP slot of a compatible switch, router or transceiver cage until it clicks into place. Connect duplex LC multimode fiber patch cables to the module, observing correct transmit/receive orientation. After physical installation, verify link status in the network device management interface and configure interface settings such as speed and duplex if required. For removal, power down or disable the port if recommended by the equipment manufacturer, then press the module latch and pull the module straight out.

Recommendations

Use multimode fiber of the appropriate grade and quality for distances up to 2 km and ensure LC connectors are clean before mating. Confirm compatibility with the host device vendor’s supported transceiver list and follow equipment-specific guidelines for hot-plugging and handling to avoid electrostatic or mechanical damage.