Módulo transceptor XFP BlueOptics XFP-LX-SM1310-D-BO 10000 Mbit/s 1310 nm

The BlueOptics XFP-LX-SM1310-D-BO is an XFP transceiver module engineered for 10 Gbit/s fiber-optic links at a 1310 nm wavelength. Housed in a durable metal enclosure and running from a 3.3 V supply, this compact module weighs approximately 2 g and is intended for installation in compatible XFP ports to enable high-speed, single-mode connections. The product name and specifications make it suitable for network equipment that requires a 10,000 Mbit/s uplink or backbone connectivity over 1310 nm single-mode fiber.

Advantages

The module provides stable 10 Gbit/s transmission over single-mode fiber at 1310 nm while maintaining a small physical footprint and low weight. The metal housing contributes to electromagnetic shielding and mechanical durability, and the standard XFP interface ensures compatibility with a wide range of networking devices that accept XFP modules. Rated for a 3.3 V input, the transceiver integrates easily into systems designed for XFP compliance.

Suitable for

• 10 Gbit/s single-mode fiber links at 1310 nm
• Core and aggregation switches, routers with XFP slots
• Data center uplinks and carrier-grade backbone connections
• Long-distance point-to-point fiber connections where 1310 nm is specified

Key specifications

• Interface type: XFP
• Nominal wavelength: 1310 nm
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Supply voltage: 3.3 V
• Housing material: metal (silver finish)
• Weight: approx. 0.002 kg

How to use

Ensure that the host device supports XFP transceiver modules and that the firmware accepts third-party modules if applicable. With power to the host device turned off or following hot-plug guidance from the equipment manufacturer, insert the transceiver into an XFP slot until it seats securely and the latch engages. Connect the single-mode fiber optic cable terminated for 1310 nm operation to the module’s optical connector. Power on the host device and verify link status and negotiated speed via the device management interface or LEDs. Follow vendor instructions for any required configuration or diagnostics.

Recommendations

Use single-mode fiber rated for 1310 nm and employ correct connector types and end-face cleaning procedures to avoid optical loss. Verify compatibility with the network equipment manufacturer and observe electrostatic discharge (ESD) precautions when handling the module. For reliable long-term operation, monitor link parameters and maintain firmware compatibility with the host system.