Módulo transceptor XFP BlueOptics XFP10GLR192SR-RGD-BO 10000 Mbit/s 1310 nm

The BlueOptics XFP10GLR192SR-RGD-BO is an XFP transceiver module engineered for 10 Gbps fiber links. It transmits and receives optical signals at a wavelength of 1310 nm and is built into a metal housing that provides mechanical protection and EMI shielding. The module requires a 3.3 V input supply and has a compact, lightweight form factor (20 g), allowing integration into a variety of network devices that accept XFP interfaces.

Advantages

This XFP transceiver supports a maximum data transfer rate of 10000 Mbit/s and complies with XFP interface requirements to ensure compatibility with equipment that uses this form factor. The metal enclosure improves durability and thermal dissipation while the standard 1310 nm wavelength enables reliable performance on single-mode fiber links over medium to long distances. Its low weight and standard dimensions simplify handling and installation in rack-mounted or chassis-based networking systems.

Suitable for

• 10 Gigabit Ethernet and optical transport networks using XFP ports
• Single-mode fiber links operating at 1310 nm wavelength
• Network equipment upgrades and replacements where XFP transceivers are supported
• Environments requiring a compact, metal-housed optical module

Key specifications

• Interface type: XFP
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Optical wavelength: 1310 nm
• Housing material: metal
• Input voltage: 3.3 V
• Weight: 0.02 kg
• Product colour: silver

How to use

Verify that the host device supports XFP transceivers and that firmware or hardware compatibility is met. Power down the port or follow hot-swap procedures recommended by the equipment manufacturer, align the transceiver with the XFP slot, and insert it until it seats securely. Connect the single-mode fiber using the appropriate connector and verify link status indicators on the host. If necessary, configure the host interface for 10 Gbps operation and monitor optical power and error statistics through the management interface.

Recommendations

Handle the transceiver by the housing, avoid touching the optical interfaces, and keep connector dust caps on when not in use. Use appropriate ESD precautions and maintain operating conditions within the equipment manufacturer's specified temperature and humidity ranges to ensure reliable performance.