Mortero de inyección FISCHER FIS V Zero 300 T, 6 × 300 ml cartuchos (verde)

FISCHER FIS V Zero 300 T — 6 × 300 ml green cartridges is a two-component injection mortar supplied as six matched 300 ml cartridges intended for anchoring studs, through-bolts and rebar in concrete and masonry. The system is used with a static mixer and an injection gun to dose and mix resin and hardener on demand. The formulation is engineered to deliver high bond strength and controlled curing, making it appropriate for structural connections, reinforcement anchoring and fixings that require reliable load transfer and resistance in cracked and uncracked substrates.

Advantages

The cartridge pack provides matched resin and hardener volumes in a compact, colour-coded package for consistent mixing and simplified onsite handling. Using the product with a static mixer produces a homogeneous two-component mixture that cures to form a durable bond capable of transferring tensile and shear loads. The cartridges are compatible with standard injection guns and mixers, reducing waste and allowing precise dosing for each installation. The system is suitable for applications where predictable cure behaviour and strong adhesion to concrete and masonry are required.

Suitable for

• Anchoring threaded rods and bolts in cracked and uncracked concrete
• Bonding rebar for structural reinforcement
• Through-bolt fixings in masonry and natural stone
• Connections requiring high bond strength and controlled curing
• Installations using static mixers and injection guns

Key specifications

• Packaging: pack of six 300 ml dual-component cartridges
• Colour: green cartridges for easy identification
• System type: two-component resin and hardener for injection application
• Application method: to be applied with a compatible static mixer and injection gun
• Suitable substrates: concrete and masonry (including cracked and uncracked concrete)
• Intended uses: anchoring, rebar bonding, through-bolt and structural fixings

How to use

Prepare the hole by cleaning to the required depth and diameter according to anchor and substrate specifications. Fit a compatible static mixer to the cartridge outlet and load the cartridges into a suitable injection gun. Dispense and discard the initial extruded material until a uniform mixed colour is achieved, then inject the mortar into the hole from the rear to the front to avoid trapped air. Insert the anchor or rebar into the wet mortar and allow the specified curing time before loading. Follow manufacturer guidance for drill diameter, embedment depth and curing periods for the chosen anchor and substrate.

Recommendations

Store cartridges in a cool, dry place and protect from freezing and direct heat. Use cartridges before the end of their stated shelf life and always follow safety data sheet instructions regarding ventilation, skin and eye protection. For reliable performance, use recommended static mixers, injection guns and installation parameters specific to anchor diameters and substrate conditions.