HVLP AURITA H-827 600ml 1,7mm pistola de pintura

Professional HVLP gravity-feed spray gun delivering high transfer efficiency and a flawless finish for automotive and industrial coatings. With a 1.7 mm stainless steel nozzle and 600 ml HDPE cup, it atomizes basecoats, clearcoats, primers, lacquers, and stains with minimal overspray. The lightweight aluminum body and ergonomic handle reduce fatigue during long sessions, while three independent controls—fluid, fan pattern, and air pressure—allow precise adjustment for any job. Operating at 2.0–3.5 bar with an average air consumption of 140–280 L/min, this gun suits compressors from 2 HP or 50 L tank and above.

Advantages

HVLP technology transfers up to 65% of coating to the surface, saving material and reducing overspray. The stainless steel nozzle and needle resist wear and corrosion, ensuring consistent atomization over time. A large 600 ml cup minimizes refills, and the quick-release design simplifies cleaning. The adjustable fan pattern from a fine spot to a wide 250 mm spray allows versatility across panels, edges, and complex shapes. The ergonomic handle and balanced weight distribution provide comfort during extended use, while the 1/4" NPT air inlet fits standard hoses and fittings.

Suitable for

• Automotive refinishing: basecoats, clearcoats, primers
• Woodworking: lacquers, stains, sealers
• Industrial coatings: enamels, urethanes, epoxies
• Hobby and DIY projects requiring professional results
• Small to medium production environments

Key specifications

• Spray technology: HVLP (High Volume Low Pressure)
• Feed type: Gravity
• Nozzle size: 1.7 mm
• Cup capacity: 600 ml
• Air inlet: 1/4" NPT
• Operating pressure: 2.0–3.5 bar (29–50 PSI)
• Air consumption: 140–280 L/min (5–10 CFM)
• Maximum pattern width: 250 mm (10")
• Fluid output: 160–240 ml/min
• Body material: Aluminum alloy
• Nozzle and needle: Stainless steel
• Cup material: High-density polyethylene (HDPE)
• Adjustments: Fluid control, fan pattern, air pressure
• Recommended compressor: 2 HP or 50 L tank minimum

Recommendations

For best results, use a clean, dry air supply with a regulator and moisture trap. Thin coatings according to manufacturer's instructions and test spray on a sample panel. Clean the gun thoroughly after each use with appropriate solvent, and lubricate moving parts periodically. Keep spare nozzle and needle kits for different viscosities. This gun is ideal for professionals seeking a reliable, high-quality finish without overspray waste.