PATRIOT Extreme Performance Viper Steel RGB - DDR4

The Patriot Memory Viper Steel DDR4 32GB 3200MHz module provides 32 GB of DDR4 system memory at a 3200 MHz clock speed in a 288-pin DIMM form factor. Designed for desktop PC and server environments, this module uses 1.35 V operating voltage and is specified with a CAS latency of 18. The Viper Steel design incorporates an aluminum heatshield to assist thermal dissipation and maintain stable operation under sustained loads. The module is compatible with modern Intel and AMD platforms and supports XMP 2.0 for simplified performance tuning.

Advantages

This memory module combines a 32 GB capacity with a 3200 MHz frequency to support multitasking, large datasets and memory-intensive applications. The aluminum heatshield helps dissipate heat to preserve performance during extended use. Low-voltage DDR4 operation at 1.35 V balances performance and power consumption, while XMP 2.0 support allows straightforward application of optimized timings and frequency settings on compatible motherboards. The 288-pin DIMM form factor ensures compatibility with standard desktop memory slots.

Suitable for (tasks / use cases)

• Multitasking and productivity workloads
• Content creation and video editing
• Gaming on modern Intel and AMD platforms
• Virtual machines and server-side memory demands
• Memory upgrades for desktop systems requiring higher capacity

Key specifications

• Capacity: 32 GB
• Memory type: DDR4
• Clock speed: 3200 MHz
• CAS latency: 18
• Operating voltage: 1.35 V
• Form factor: 288-pin DIMM
• Heat dissipation: aluminum heatshield
• Profile support: XMP 2.0
• Typical weight: 0.096 kg

How to use

Power down the PC and disconnect it from mains power before installing the module. Open the system case, locate the appropriate 288-pin DIMM slot on the motherboard, and align the module with the slot notch. Press firmly and evenly on both ends until the retention clips engage. Reconnect power and start the system. Enter the motherboard BIOS/UEFI if you wish to enable an XMP 2.0 profile for the specified 3200 MHz frequency and timings; save changes and reboot. Verify system stability with typical workloads or memory stress tools after configuration.

Recommendations

Install modules in matched pairs or configurations recommended by the motherboard manufacturer to enable dual- or multi-channel operation and maximize memory bandwidth. Use the motherboard manual to confirm supported frequencies and enable XMP 2.0 only on compatible boards to apply intended timings. Maintain adequate case airflow to ensure effective heat dissipation from the aluminum heatshield during prolonged high-load operation.