Punta de disco de diamante 2 mm Dremel 26157103JA

The Dremel Diamond Wheel Point 2 mm (MPN 26157103JA, EAN 8710364044832) is a small-diameter diamond-coated rotary tool bit for fine detail work on hard materials. With a 2 mm cutting diameter and a total length of 45 mm, this single-piece accessory is intended for precision cutting, engraving, carving, touch-up and finishing on items such as wood, glass, metal and semi-precious stones.

Advantages

The diamond-coated tip provides high wear resistance and consistent cutting performance on hard surfaces. Its 2 mm diameter allows controlled, accurate detail work in tight areas. Compatible with Dremel rotary tools, the bit is suitable for delicate engraving and finishing tasks where a small profile and long-lasting abrasive action are required.

Suitable for

• Fine engraving on glass and ceramic
• Detail carving and touch-up on wood
• Cutting and shaping of semi-precious stones and jade
• Precision work on hardened steel and other hard materials

Key specifications

• Brand: Dremel
• MPN: 26157103JA
• EAN: 8710364044832
• Type: Diamond wheel point (diamond-coated bit)
• Diameter: 2 mm
• Length: 45 mm
• Pack quantity: 1 piece

How to use

Fit the 2 mm diamond wheel point into the collet or chuck of a compatible Dremel rotary tool according to the tool manufacturer’s instructions. Select an appropriate speed for the material—lower speeds for ceramics and glass to reduce chipping, moderate to higher speeds for metals and stone. Apply light, steady pressure and move the bit smoothly across the work surface to avoid heat build-up. Use water or coolant if recommended for the material to prolong bit life and reduce dust.

Recommendations

Wear appropriate personal protective equipment (safety glasses, dust mask and gloves) and ensure secure clamping of workpieces. Do not force the bit; allow the diamond abrasives to cut by light, consistent contact. Store the bit dry and inspect for wear before each use.