Cable de red S/CONN 75717 gris 7,5 m Cat6a S/FTP

The ShiverPeaks Networking Cable S/CONN 75717 Grey 7.5m Cat6a S/FTP is a 7.5-metre Ethernet cable designed to support high-speed network connections in home and office environments. Built to Cat6a standard with S/FTP shielding, it reduces electromagnetic interference and crosstalk to maintain reliable data throughput. The cable terminates in RJ-45 connectors with gold-plated contacts to improve signal transmission and resist corrosion, while the grey jacket provides a neutral appearance suitable for visible installations.

Advantages

The S/FTP construction (screened foil around each twisted pair plus an overall braid) provides enhanced protection against external interference compared with unshielded alternatives, supporting stable high-bandwidth performance. Cat6a specification allows for higher data rates and improved frequency handling relative to lower-category cables, enabling use in demanding network segments. Gold-plated RJ-45 connectors offer improved contact reliability and longevity, and the 7.5 m length provides flexibility for typical room-to-room or desk-to-switch connections without excessive slack.

Suitable for

• Gigabit and 10 Gigabit Ethernet connections within LANs
• Connecting desktops, laptops, switches, routers and NAS devices
• Office and home network cabling where reduced interference is required
• Structured cabling runs where a 7.5 m fixed-length cable fits routing needs

Key specifications

• Category: Cat6a
• Shielding: S/FTP (foil around pairs with overall braid)
• Length: 7.5 metres
• Connector type: RJ-45
• Contact plating: gold-plated contacts
• Color: grey

How to use

Plug one RJ-45 connector into the network port of your device (PC, switch, router, or NAS) and the other connector into the corresponding port on the network equipment. Ensure connectors are fully inserted until they click to establish reliable contact. Route the cable avoiding sharp bends and sources of strong electromagnetic noise where possible. For permanent routes, use appropriate cable management to prevent strain on the connectors and maintain signal integrity.

Recommendations

For optimal performance, keep cable lengths under the maximum recommended run for structured cabling environments and avoid tightly coiling the cable. When installing near potential sources of interference (power supplies, fluorescent lighting, large motors), maintain separation or use the shielded cable routing to minimise noise. Periodically inspect connectors for damage or corrosion and replace the cable if physical wear affects connectivity.