Set de conectores coaxiales F de compresión ShiverPeaks 85029-A-SET2 para cable de 7 mm, 2 piezas

The ShiverPeaks coaxial F-compression connector set 85029-A-SET2 is designed for reliable termination of 7 mm outer-diameter coaxial cables. This two-piece set contains F-type compression connectors that create a solid mechanical and electrical connection for TV, satellite and broadband installations. The connectors are intended for use where a stable, low-loss connection is required and can be used to replace damaged connectors or to terminate new cable runs.

Advantages

These F-compression connectors provide consistent contact pressure and a secure fit on 7 mm coaxial cables, minimising signal loss and improving shielding continuity. The compression design ensures a durable mechanical connection that resists loosening from vibration or handling. The two-piece set simplifies inventory for small installation tasks and quick repairs.

Suitable for

• Termination of 7 mm outer-diameter coaxial cables for TV distribution
• Satellite antenna cable connections
• Broadband and cable modem installations
• Replacing worn or damaged F-connectors during maintenance

Key specifications

• Connector type: F-type compression connector suitable for 7 mm coaxial cable
• Set quantity: 2 connectors
• Function: Mechanical compression termination for reliable electrical contact
• Compatibility: Standard 7 mm outer-diameter coax cables used in TV, satellite and broadband systems

How to use

Prepare the coaxial cable by stripping the outer jacket, braid and dielectric to the dimensions recommended for the compression connector. Insert the cable into the connector so the centre conductor engages the pin contact and the braid is positioned for proper shielding contact. Use an appropriate compression tool to compress the connector onto the cable until it is fully seated. Verify the connection by gently pulling the connector and checking signal continuity with test equipment if available.

Recommendations

Use a matching compression crimping tool designed for F-type compression fittings and verify stripping dimensions for 7 mm cables before installation. Avoid excessive torque and ensure the centre conductor is straight and properly positioned to prevent signal loss.