Cable de red S/CONN 75711-H0.25W-SET10

The ShiverPeaks Networking Cable S/CONN 75711-H0.25W-SET10 is a 0.25 m Cat6 patch cable designed for short-distance network connections. It features S/FTP shielding to reduce electromagnetic interference and RJ-45 connectors with gold plating to improve contact reliability and signal transmission. The white jacket provides a discreet, clean appearance suitable for residential and office environments, while the compact length minimizes excess cable and clutter.

Advantages

S/FTP shielding combines an overall foil shield with individually shielded pairs to offer enhanced protection against crosstalk and external interference. Cat6 performance supports higher data rates and improved signal integrity compared with lower category cables. Gold-plated RJ-45 contacts ensure consistent conductivity and reduced oxidation over time. The 0.25 m length is useful for connecting equipment located close together without unnecessary cable slack.

Suitable for

• Short connections between network devices such as routers, switches, and patch panels
• Connecting a desktop or laptop to a nearby wall socket or access point
• Tidy installations behind desks or in compact networking cabinets
• Temporary or permanent links in home and small office networks

Key specifications

• Category: Cat6
• Cable length: 0.25 m
• Shielding: S/FTP (overall foil with individually shielded pairs)
• Connectors: RJ-45
• Contact finish: gold-plated contacts
• Outer jacket color: white

How to use

Plug each RJ-45 connector firmly into the Ethernet ports of the devices to be connected until the latch clicks into place. Ensure both devices are powered and that network settings are configured as required. Use the short cable to create a direct, low-latency link between nearby equipment, avoiding tight bends at the connector ends to preserve shielding and conductor integrity.

Recommendations

For optimal performance, route the cable away from high-power electrical lines and large sources of electromagnetic interference. Avoid repeated sharp bends and do not exceed the cable's flex limits near the connectors. For permanent installations, check connector seating periodically and replace the cable if visible damage to the jacket or connectors appears.