SHIVERPEAKS S/CONN maximum connectivity acoplador coaxial en ángulo conector macho F a conector hembra F 75 ohmios latón niquelado plata (82023)

When setting up a wall-mounted TV or connecting a satellite receiver in a tight cabinet, a straight connector often forces awkward cable bends that strain the coax and degrade signal quality. The SHIVERPEAKS S/CONN maximum connectivity coaxial right-angle coupler solves this by turning the connection 90 degrees, allowing the cable to run flat against the wall or along the back of the device. Its F-male to F-female configuration adapts an existing F-type cable to a device input, making it ideal for TV, SAT, DVB-T, DVB-C, and radio installations. Precision-machined from nickel-plated brass with a PTFE dielectric, this coupler ensures stable 75-ohm impedance and low insertion loss across a wide frequency range from 0 to 3000 MHz.

Key specifications

• Connector 1: F-male (plug), right-angle
• Connector 2: F-female (jack), straight
• Impedance: 75 Ω
• Frequency range: 0–3000 MHz
• Body material: Nickel-plated brass
• Dielectric: PTFE
• Insertion loss: < 1 dB
• Return loss: > 18 dB
• Shielding effectiveness: High
• Operating temperature: -20°C to +70°C
• RoHS compliant: Yes
• Packaging: Single piece

Why choose it

The 90-degree angle eliminates sharp cable bends that cause signal reflection and premature cable failure, especially behind wall-mounted TVs or inside crowded media cabinets. Nickel-plated brass construction resists corrosion and provides excellent shielding against electromagnetic interference. The PTFE dielectric maintains consistent impedance and minimises signal loss, ensuring clear picture and sound for digital TV and satellite signals. Its screw-on F-type connectors provide a secure, weather-resistant connection suitable for both indoor and outdoor use.

Ideal use cases

• Wall-mounted TV installations where space behind the screen is limited
• Satellite and cable TV receiver connections in tight cabinets
• DVB-T/DVB-C antenna setups requiring a low-profile cable exit
• Radio frequency distribution systems needing right-angle transitions
• Test and measurement setups where cable routing must avoid obstructions

Good to know

This coupler is a single piece, so order the quantity needed for each connection point. It is designed for 75-ohm coaxial systems and should not be used with 50-ohm equipment. The nickel-plated finish gives it a silver appearance that blends with most AV components. For outdoor use, ensure the connection is properly sealed with weatherproof tape or boots to prevent moisture ingress.