Team Group Team Elite - DDR4 - módulo - 8 GB - DIMM 288-PIN

The Team Group ELITE DDR4 8GB 3200MHz (model TED48G3200C2201) is a 288-pin DIMM memory module for PCs and servers. It operates at 1.2 V with a 3200 MHz clock and CAS latency 22, offering a standard-compliant DDR4 upgrade that balances performance, power efficiency and broad motherboard compatibility.

Advantages

QVL-approved across mainstream DDR4 motherboards to reduce compatibility concerns. The module follows JEDEC specifications and is compatible with Intel X99 chipset platforms. Operating at 1.2 V, it consumes less power than previous-generation modules and produces less heat, contributing to stable system temperatures. Available in single- and dual-channel configurations and offered in kits up to 32 GB (16 GB x2) to support higher data throughput.

Suitable for

• General desktop PCs requiring a reliable 8 GB DDR4 module
• Workstations and entry-level servers using 288-pin DIMM slots
• Systems where lower power consumption and reduced heat generation are desired

Key specifications

• Capacity: 8 GB
• Type: DDR4
• Clock speed: 3200 MHz
• CAS Latency: CL22
• Form factor: 288-pin DIMM
• Operating voltage: 1.2 V
• Model: TED48G3200C2201

How to use

Power off the system and disconnect from mains before installation. Open the PC case, locate an empty 288-pin DIMM slot compatible with DDR4 memory, and align the module notch with the slot key. Firmly press the module into the slot until the retention clips engage. Reassemble the case, reconnect power, and verify memory recognition in BIOS/UEFI or the operating system. For dual-channel operation, install a matched module pair in the motherboard’s recommended slots.

Recommendations

Install this Team Group ELITE DDR4 module on motherboards listed in the board manufacturer’s QVL for best compatibility. Use matching modules for dual-channel configurations and ensure BIOS/UEFI settings (frequency and timings) match the module’s specifications or AUTO/XMP profile where supported.