Teléfono IP móvil Yealink W73P Gris TFT

The Yealink W73P is a DECT IP mobile phone system with a 1.8" TFT display (128 × 160 pixels) and a grey finish. The base supports registration of up to 10 Yealink W73H handsets, up to 10 SIP accounts and up to 20 simultaneous calls. The system accepts a phonebook of up to 100 entries and uses a 1010 mAh lithium-ion battery in each handset. It supports an input voltage of 100–240 V and can be expanded with up to 6 optional repeaters for wider coverage, making it suitable for small and medium business environments and home office use.

Advantages

The W73P delivers HD audio quality, improved signal strength and upgraded hardware and acoustic algorithms for clear and stable cordless communication, including noise reduction and higher call volume for noisy environments. It offers scalable capacity for multiple handsets and simultaneous calls, plus compatibility with Yealink's range of DECT endpoints (handsets, conference phones and DD phones). The base supports remote provisioning and mass deployment via Yealink Redirection and Provisioning Service (RPS) and boot mechanisms to simplify setup, maintenance and upgrades.

Suitable for

• Small and medium businesses needing a scalable cordless IP phone system
• Offices and reception areas requiring multiple handsets and concurrent calls
• Workplaces with noisy environments that require clear, noise-reduced audio
• Sites needing extended DECT coverage using optional repeaters

Key specifications

• Display: 1.8" TFT, 128 × 160 pixels
• Handset support: up to 10 W73H handsets
• SIP accounts: up to 10
• Simultaneous calls: up to 20
• Phonebook capacity: 100 entries
• Battery: Lithium-Ion, 1010 mAh (handset)
• Power input: 100–240 V
• Expandable coverage: up to 6 optional DECT repeaters
• Compatibility: Yealink DECT endpoints (handsets, conference phones, DD phones)

How to use

Install the W73P base and connect it to power (100–240 V) and the network. Register Yealink W73H handsets to the base following the handset pairing procedure. Configure SIP accounts on the base either via the web interface or by using Yealink RPS for remote provisioning. Place repeaters if required to extend DECT range and ensure stable reception. Charge handsets using the provided chargers and monitor battery levels; replace or recharge when the 1010 mAh battery level is low.

Recommendations

For reliable performance, position the base centrally within the coverage area and use optional repeaters in large or multi-floor environments. Use Yealink RPS for bulk deployments and keep firmware up to date to maintain stability and compatibility with other Yealink DECT devices.