Transceptor de fibra óptica BlueOptics SU69CA 10000 Mbit/s XFP 1310 nm

The BlueOptics SU69CA is a fiber optic transceiver designed for 10 Gbit/s network links using the XFP form factor. Operating at a wavelength of 1310 nm, this module supports high-speed serial data transmission up to 10000 Mbit/s and is suitable for use in optical single-mode or short-reach applications that accept XFP interfaces. The transceiver offers a compact, hot-pluggable solution for expanding or upgrading network equipment where an XFP port is available.

Advantages

This XFP transceiver provides stable 10 Gbit/s performance with a standardized interface for compatibility with a range of networking devices. Its optical wavelength of 1310 nm is appropriate for medium-range single-mode fiber links, enabling dependable transmission over typical campus, data center interconnects, or carrier networks. The module’s form factor and electrical compatibility simplify installation and replacement without powering down connected hardware.

Suitable for

Key specifications

How to use

Install the transceiver into an available XFP port on a compatible switch, router or optical transport device while the host device is powered according to vendor guidance for hot-pluggable modules. Connect an appropriate single-mode optical fiber patch cable to the transceiver’s optical interface, observing correct connector type and polarity. After insertion and connection, verify link status and negotiated speed via the host device’s management interface and monitor for optical power and error statistics to confirm proper operation.

Recommendations

Use certified single-mode fiber and compatible connectors to ensure optimal optical performance. Verify that the network equipment firmware supports third-party XFP modules and configure link parameters if required. Maintain clean fiber end-faces and follow static-safe handling practices when installing or removing the transceiver.