Transceptor óptico SFP 10Gb NETAPP SHRTWV (modelo 332-00279R6-RFB)

NETAPP SFP 10Gb Optical Transceiver SHRTWV (332-00279R6-RFB) is a small form-factor pluggable (SFP+) module designed for 10 Gigabit Ethernet short-range fiber connections in compatible NETAPP systems and switches. The transceiver supports hot-swappable installation and is intended for use in data center uplinks, server interconnects and SAN environments where reliable 10Gb optical links are required. The module is identified by NETAPP part number 332-00279R6-RFB and EAN 5715328110649.

Advantages

The NETAPP SHRTWV SFP+ transceiver provides a compact, vendor-approved solution for short-range 10Gb fiber links, enabling straightforward replacement or upgrade with hot-swap capability. Its compatibility with NETAPP hardware simplifies inventory and deployment in homogeneous NETAPP environments and helps maintain consistent link performance in data center and SAN topologies.

Suitable for

• Data center uplinks and top-of-rack switch connections
• Server-to-switch 10Gb fiber interconnects
• Storage area network (SAN) links requiring 10Gb optical connectivity
• Short-range fiber patching inside racks or between adjacent cabinets

Key specifications

• Brand: NETAPP
• Model / MPN: 332-00279R6-RFB (SHRTWV)
• Form factor: SFP+ (small form-factor pluggable)
• Data rate: 10 Gigabit Ethernet
• Package: hot-swappable transceiver module
• EAN: 5715328110649

How to use

Insert the NETAPP SFP+ transceiver into a compatible SFP+ port on a NETAPP switch, storage controller or other supported device following the host vendor's hot-swap procedures. Ensure the fiber cabling (appropriate single-mode or multimode fiber as specified by the host and link requirements) and connectors match the transceiver and remote port. Verify link status and network configuration on the connected devices after installation. When replacing a transceiver, follow standard ESD precautions and power/port handling recommendations provided by the equipment manufacturer.

Recommendations

Use the transceiver in NETAPP systems or confirmed-compatible network equipment to ensure full interoperability. Match the fiber type and connector type to the transceiver and the remote endpoint, and verify firmware and port settings on network devices when troubleshooting link issues.