Transceptor QSFP de fibra óptica BlueOptics AXLM762-10000S-BO 10000 m

The BlueOptics AXLM762-10000S-BO is a fiber optic QSFP transceiver engineered for high-speed optical links up to 10,000 meters over single-mode fiber. Housed in a lightweight aluminium body and weighing just 20 g, this module is designed to fit industry-standard QSFP slots and provide reliable 40G data transmission for networking equipment that supports 40GBASE-LR4 applications. It uses LC Duplex connectivity and incorporates CWDM-enabled transmitter and receiver sections to carry multiplexed optical signals across long distances while keeping form factor and weight minimal.

Advantages

The transceiver offers long-reach performance for up to 10 km on single-mode fiber and supports 40G data rates suitable for Ethernet and related high-speed protocols. Its aluminium housing provides physical durability and thermal dissipation while the compact 20 g design simplifies handling and installation in dense data center environments. The module is designed to comply with common MSA QSFP mechanical and electrical specifications and includes support for digital diagnostics (DDM/DOM) to monitor operating parameters such as supply voltage, laser current, optical power and temperature when supported by host hardware.

Suitable for

Key specifications

How to use

Insert the BlueOptics AXLM762-10000S-BO into a compatible QSFP cage of your switch, router or other network device while the host is powered down or following the device vendor’s hot-swap instructions. Connect LC Duplex single-mode fiber patch cords to the transceiver’s ports, observing correct transmit/receive orientation. Ensure the connected fiber link, patch panel and remote transceiver are suitable for 40GBASE-LR4 operation and that the host device firmware or drivers accept third-party QSFP modules. If available, enable and read the DDM/DOM values from the host management interface to verify optical power, temperature and other live diagnostics.

Recommendations

Use single-mode LC Duplex fiber patch cords rated for 10 km or longer and maintain clean connector end-faces to ensure optimal signal quality. Verify compatibility with the target switch or router model and enable digital diagnostics on the host to monitor link health. For best results in data center environments, route fibers through appropriate management panels and avoid excessive bending radii.