Transceptor SFP BlueOptics 569025 1250 Mbit/s 1310 nm

The BlueOptics 569025 SFP transceiver is a compact optical module designed for fiber optic networks and SFP-compatible ports. It supports a maximum data transfer rate of 1250 Mbit/s and transmits at a wavelength of 1310 nm. The module enables single-mode fiber connections over typical short- to medium-range distances and fits standard SFP slots used in switches, routers and media converters.

Advantages

This BlueOptics SFP transceiver provides a straightforward solution for adding fiber connectivity without modifying existing equipment. Its small form factor and industry-standard SFP interface make it compatible with many networking devices. Operating at 1310 nm with a 1250 Mbit/s transfer rate, the module delivers predictable throughput and stable optical performance for data, voice or video traffic.

Suitable for

• Upgrading copper ports to fiber on switches and routers
• Connecting network segments over single-mode fiber links
• Use in media converters and SFP-capable network appliances
• Short- to medium-reach fiber backbone or access links

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Optical wavelength: 1310 nm
• Maximum data rate: 1250 Mbit/s
• Fiber type: single-mode (typical)
• Connector type: LC (typical for SFP optical modules)
• Power and thermal characteristics: low-power SFP class (device-specific values depend on host)

How to use

Insert the transceiver into an available SFP slot on the host device until it clicks into place, then connect the single-mode fiber cable using the LC connector. Ensure the host device is powered down or follows hot-swap guidelines provided by the equipment manufacturer when installing or removing modules. After physical installation, verify link status and configure the device interface according to network settings (speed, duplex and any required optical settings) to enable data transmission at 1250 Mbit/s.

Recommendations

Use clean connectors and proper fiber handling to maintain optimal signal quality. Verify compatibility with the host device and consult device documentation for supported optical modules. For reliable performance, match fiber type and connector, and operate the module within the ambient temperature and power specifications of your networking equipment.