Transceptor SFP BlueOptics AA1419081-E5-NT-BO 155 Mbit/s fibra óptica

The BlueOptics AA1419081-E5-NT-BO is an SFP transceiver module for fiber optic links, supporting a maximum data transfer rate of 155 Mbit/s. Housed in a compact SFP form factor with a silver finish, the module is intended for installation in compatible network equipment to enable single-mode or multi-mode fiber connections depending on system design. It is designed for continuous operation and carries compliance declarations for CE, FCC and RoHS.

Advantages

This SFP transceiver provides a standardized, hot-pluggable interface for fiber connections in switches, routers and media converters, offering a balance of compact size and reliability. With an MTBF of approximately 1,000,000 hours and a lightweight metal enclosure, the module supports stable optical links while meeting common regulatory standards for safety and emissions.

Suitable for

• Upgrading or extending fiber optic connections in enterprise or industrial networks
• Use in SFP-compatible switches, routers and media converters
• Replacement of existing 155 Mbit/s fiber transceivers in legacy systems

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 155 Mbit/s
• Product colour: Silver
• Weight: 0.02 kg
• Mean time between failures (MTBF): 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS
• Form factor: hot-pluggable SFP module

How to use

Power down or follow your equipment vendor's hot-swap procedure, then insert the SFP transceiver into an SFP port until it seats securely. Connect the appropriate fiber optic cable to the transceiver's optical interface, ensuring correct connector type and polarity. Configure the host device for the transceiver's link speed and optical settings if required by the system. Monitor link LEDs or device diagnostics to confirm operation.

Recommendations

Store and operate the transceiver within the environmental limits specified by your network equipment vendor. Use compatible fiber cables and connectors, and observe electrostatic discharge (ESD) precautions when handling the module. Replace dust caps when the transceiver is not in use to protect the optical interfaces.