Transceptor SFP BlueOptics ABCU-5741ARZ-BO fibra óptica 1000 Mbit/s

The BlueOptics ABCU-5741ARZ-BO is an SFP fiber optic transceiver designed for Gigabit Ethernet connections with a maximum data transfer rate of 1000 Mbit/s. The module is housed in an aluminium enclosure, providing a lightweight (20 g) and mechanically robust form factor suitable for standard SFP ports. It supports Ethernet transmission over twisted-pair copper when used with the appropriate RJ45 adapter and follows industry MSA form-factor conventions for interoperable insertion into compatible networking equipment.

Advantages

The transceiver combines compact SFP sizing with a metal housing for improved durability and thermal behaviour. Its 1000 Mbit/s capability enables use in standard Gigabit Ethernet networks while the low weight simplifies handling and installation in dense chassis environments. Compliance with common SFP mechanical and electrical conventions increases the likelihood of plug-and-play behaviour in supported switches, routers and storage systems.

Suitable for

• Gigabit Ethernet uplinks and downlinks in enterprise and SMB networks
• Switch and router SFP ports that accept standard SFP transceivers
• Edge and aggregation connections where a compact RJ45-capable SFP is required
• Temporary or permanent port upgrades where copper connection via SFP form factor is preferred

Key specifications

• Interface type: SFP form factor
• Maximum data transfer rate: 1000 Mbit/s (Gigabit Ethernet)
• Construction material: aluminium housing
• Weight: 0.02 kg
• Connector type: RJ45 electrical interface (used with appropriate adapter/cable)

How to use

Insert the BlueOptics SFP transceiver into an empty SFP port on a compatible switch, router or storage device while the host device is powered down or according to the vendor’s hot-swap guidance. Connect a suitable twisted-pair copper cable to the RJ45 interface of the transceiver or its RJ45 adapter to establish the physical link. Configure the host network interface if required by your equipment (auto-negotiation settings, VLANs, speed/duplex preferences). Monitor the link status on the host device to confirm successful negotiation at 10/100/1000 Mbit/s, and verify network performance with standard diagnostic tools.

Recommendations

Use shielded or unshielded twisted-pair cables that meet Category 5e or better for reliable Gigabit performance and keep cable runs within recommended distances (up to 100 metres for copper Ethernet). When installing multiple SFPs in a chassis, ensure adequate airflow around modules and follow the equipment manufacturer’s compatibility list to avoid firmware-level incompatibilities.