Transceptor SFP BlueOptics BO05A13610D 100BASE-LX fibra monomodo 10 km

BlueOptics BO05A13610D is an SFP transceiver module supporting 100BASE-LX operation over singlemode fiber with a reach of up to 10 km. The module fits standard SFP ports and provides a 100 Mbps Ethernet link for connecting network equipment such as switches, routers and media converters across campus or metropolitan links. The hot‑swappable design enables replacement or upgrade without powering down the host device.

Advantages

The BlueOptics 100BASE-LX SFP delivers a standardized electrical and optical interface for reliable 100 Mbps fiber connections and is compatible with devices that accept SFP form factor modules. Singlemode operation and 10 km reach enable long-distance point-to-point links while maintaining low latency characteristic of copper-free fiber connections. Hot-swappability and compact SFP size simplify installation, spare management and on-site maintenance.

Suitable for

• Connecting switches and routers over singlemode fiber for campus backbone links
• Linking media converters to integrate fiber segments with existing copper networks
• Establishing short metropolitan or inter-building Ethernet links up to 10 km
• Replacing failed SFP modules or upgrading port optics without changing hardware

Key specifications

• Form factor: Small Form-factor Pluggable (SFP)
• Standard: 100BASE-LX Ethernet
• Fiber type: Singlemode fiber
• Maximum link distance: up to 10 km (singlemode)
• Data rate: 100 Mbps
• Connector type: LC duplex
• Operating mode: Hot‑swappable

How to use

Insert the SFP transceiver into an available SFP port on a compatible switch, router or media converter until it seats firmly. Connect singlemode fiber patch cords with LC duplex connectors to the transmit and receive ports, observing correct polarity. After insertion the host device should recognize the transceiver and negotiate a 100 Mbps link; verify link status via the device management interface or LED indicators. For removal, power down only if recommended by the host device; otherwise, use the hot‑swap procedure described by the equipment vendor.

Recommendations

Use singlemode fiber with appropriate attenuation budget for best performance, maintain clean LC connectors to avoid signal loss, and verify compatibility with host hardware for optical wavelength and power budget. Store spare modules in anti‑static packaging and avoid exposure to dust or moisture when installing or servicing fiber links.