Transceptor SFP+ BlueOptics F5-UPG-SFP+LR-R-BO, alcance 10 km, 1310 nm

The SFP+ Transceiver BlueOptics F5-UPG-SFP+LR-R-BO is a hot-pluggable optical module designed for 10 Gbps SFP+ ports. It operates over single-mode fiber at a wavelength of 1310 nm and supports link distances up to 10 km, making it suitable for uplinks, server connections and network aggregation. The module follows the industry-standard SFP+ form factor and provides a compact solution for extending high-speed links between switches, routers and optical equipment.

Advantages

This transceiver offers reliable 10 Gbps throughput with low power consumption and a standardized SFP+ interface for broad compatibility with networking hardware. Its single-mode 1310 nm optics enable stable performance over distances up to 10 km, reducing the need for intermediate equipment. The hot-pluggable design allows insertion or replacement without powering down the host device, facilitating maintenance and upgrades with minimal disruption.

Suitable for

• Data center uplinks and switch-to-switch connections
• Long-distance links within campus and metropolitan networks
• High-speed server or storage network connections
• Optical equipment requiring SFP+ form-factor transceivers

Key specifications

• Form factor: SFP+
• Data rate: 10 Gbps
• Fiber type: single-mode fiber (SMF)
• Wavelength: 1310 nm
• Maximum link distance: up to 10 km
• Connector type: LC duplex
• Optical interface: transmit and receive for single-mode
• Hot-pluggable: yes

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on a switch, router or optical device until it clicks into place. Connect single-mode fiber cables with LC duplex connectors, ensuring correct transmit-to-receive alignment. After installation, verify link status via the host device management interface or LED indicators. For safe removal, follow the device manufacturer’s hot-swap procedure to avoid link disruption or physical damage.

Recommendations

For optimal performance, use single-mode fiber rated for 1310 nm and maintain proper cable bend radius and connector cleanliness. Verify compatibility with the host device’s supported transceiver list and firmware requirements. Avoid exposing the optical ports to dust or direct sunlight and store spare modules in protective packaging when not in use.