Transceptor SFP+ BlueOptics SFP-534T 10GBASE-ER 1550 nm 40 km

The BlueOptics SFP-534T is a compact SFP+ transceiver module that supports 10GBASE-ER operation at a wavelength of 1550 nm and is specified for single-mode fiber links up to 40 km. Its hot-pluggable SFP+ form factor provides 10 Gbit/s duplex connectivity suitable for integration into switches, routers and optical transport equipment used in enterprise and carrier networks. The module is designed for long-range links where higher optical budget and single-mode fiber are required, while maintaining compatibility with standard SFP+ ports and minimal rack space usage.

Advantages

This SFP+ transceiver offers long-reach transmission to 40 km over single-mode fiber at 1550 nm, enabling extended link distances without intermediate amplification in many deployments. The hot-pluggable design reduces downtime for upgrades or replacements and simplifies maintenance. Low-power operation and a standardized SFP+ footprint allow easy integration into existing networking hardware. The module is suitable for use in diverse hardware from access switches to optical transport systems, providing reliable 10 Gbit/s optical connectivity.

Suitable for

Key specifications

How to use

Install the transceiver into an available SFP+ slot on a compatible switch, router or optical transport device, ensuring the module is fully seated until the retention latch engages. Connect LC duplex single-mode fiber patch cables with correct polarity and verify that the remote end uses a matching 10GBASE-ER transceiver or compatible receiver. After physical installation, check link status and port configuration on network equipment; enable the port and set any required speed/duplex or interface settings according to the host device documentation. Monitor optical power levels and error counters in the host system to confirm stable operation.

Recommendations

Use high-quality single-mode fiber and LC duplex connectors, maintain proper fiber cleanliness to prevent signal loss, and verify end-to-end compatibility for 10GBASE-ER links. For links approaching the 40 km limit, check optical power budget and consider dispersion or attenuation factors; use inline amplifiers or dispersion compensation only when necessary and according to network design guidelines.