Transceptor SFP BlueOptics SFP28-25G-ER-BC-BO 25000 Mbit/s 1310 nm

The BlueOptics SFP28-25G-ER-BC-BO is a single-mode fiber SFP28 transceiver module designed for high-speed optical links. It supports a maximum data transfer rate of 25 Gbit/s and operates at a wavelength of 1310 nm. Housed in a metal casing and weighing approximately 2 g, the module uses a standard SFP28 interface and requires a 3.3 V supply. The transceiver meets RoHS requirements and is intended for use in networking equipment that accepts SFP28 form-factor modules.

Advantages

The module provides a reliable 25G optical connection in a compact metal housing that aids heat dissipation and mechanical stability. Its single-mode 1310 nm design enables extended reach compared with short-range optics while maintaining a small form factor and low weight. Compliance with RoHS and standard SFP28 interface specifications supports straightforward integration into compatible switches, routers and other network devices.

Suitable for

• 25G single-mode optical links over LC duplex fiber
• High-speed uplinks between switches and routers
• Interconnects in data center and campus networks
• Applications requiring compact SFP28 transceivers with low power

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25,000 Mbit/s (25 Gbit/s)
• Wavelength: 1310 nm
• Optical mode: single-mode fiber
• Housing material: metal
• Supply voltage: 3.3 V
• Product colour: silver
• Weight: 0.002 kg

How to use

Install the transceiver into an SFP28-compatible port on your network device until it clicks into place, then connect a compatible LC duplex single-mode patch cable. Ensure the host device supports 25G operation and that firmware or vendor compatibility settings (if any) permit third-party SFP modules. After insertion, verify link status and data rate through the device management interface or LED indicators. For removal, power down the port if recommended by the hardware vendor and gently extract the module by pressing the release mechanism and pulling straight out.

Recommendations

Use LC duplex single-mode patch cables and maintain clean fiber connectors to preserve signal quality. Verify that the network hardware supports SFP28 modules at 25G and check for any vendor-specific compatibility notes. Store unused transceivers in anti-static packaging and avoid touching optical endfaces to prevent contamination.