Transceptor SFP+ BlueOptics X2129A-N 10000 Mbit/s 850 nm

The BlueOptics X2129A-N 10000 Mbit/s 850 nm is an SFP+ fiber optic transceiver designed for short-range high-speed links in data centers and enterprise networks. It supports a maximum data transfer rate of 10 Gbit/s over multimode fiber at an 850 nm wavelength and provides a compact, hot-pluggable interface that integrates with SFP+ ports on switches, routers and network interface cards. The module is intended for reliable short-range connectivity where low-latency, high-bandwidth links are required.

Advantages

The transceiver delivers 10 Gbit/s performance with an SFP+ form factor, allowing straightforward installation into compatible equipment. Operating at 850 nm, it is optimized for short-range multimode fiber links and offers a standardized optical interface for interoperability across different vendors. Its compact, hot-pluggable design minimizes downtime during maintenance or upgrades and reduces the need for additional adapter hardware.

Suitable for

Key specifications

How to use

Install the BlueOptics X2129A-N by inserting the module into an available SFP+ port on compatible networking equipment until it clicks into place. Connect appropriate multimode fiber patch cords to the transceiver's duplex optical connector, observing correct polarity. Ensure the connected equipment supports 10 Gbit/s SFP+ modules and configure port settings as required by your network management system. Monitor link status and LEDs on the host device to confirm successful link establishment.

Recommendations

Use multimode fiber rated for short-range 10 Gbit/s links and keep connector endfaces clean to maintain signal integrity. Verify compatibility with your switch or server vendor’s supported transceiver list if equipment has vendor-locked firmware. Handle the module by its housing, avoid touching the optical interface, and use dust caps when the transceiver is not in use.