Transceptor XFP BlueOptics OPT-0013-BO 10000 Mbit/s 1310 nm

The BlueOptics OPT-0013-BO is an XFP transceiver module engineered for 10 Gbit/s optical links. It operates at a wavelength of 1310 nm and supports single-mode fiber connections with LC duplex interfacing according to common MSA standards. Housed in a silver metal casing and weighing approximately 4 g, the module is powered by a 3.3 V supply and is designed for integration in networking equipment that accepts XFP form-factor transceivers.

Advantages

The module provides a standardized XFP interface for 10G data transmission over single-mode fiber, combining compact metal construction with low weight for straightforward installation. Its 1310 nm optical wavelength supports medium-range links while the 3.3 V power requirement matches common XFP power rails. The Silver metal housing contributes to mechanical robustness and thermal stability in typical networking environments.

Suitable for

Key specifications

How to use

Insert the XFP transceiver into a compatible XFP port on your switch, router or other network device while the host is powered down or following the device vendor's hot-swap guidelines. Connect LC duplex single-mode fiber patch cords to the transmit and receive ports, observing correct polarity. Ensure the host device recognizes the module and that link settings (speed, duplex, and applicable protocols) match the intended network configuration. Verify optical power and link status through the host management interface or diagnostic tools.

Recommendations

Use high-quality single-mode LC duplex patch cords and verify compatibility with the host device firmware before deployment. If available, enable and monitor digital diagnostic functions (DDM/DOM) in the host to track optical power, temperature and supply voltage for proactive maintenance.