Tubo termorretráctil CellPack 144410, 100 cm de longitud, 1 unidad

CellPack 144410 is a heat shrink tubing supplied as a single 100 cm length designed for electrical insulation and protection. It provides a thin-wall sleeve that shrinks when heated to form a tight, insulating layer around wires, connectors and cable joints. The tubing is non-adhesive, inscribable and stabilized against UV, with chemical resistance and superior electrical properties suitable for many repair and installation tasks.

Advantages

The thin-wall construction ensures compact coverage without adding significant bulk while maintaining high tensile strength and flexibility. Absence of thermoplastic adhesive makes it suitable where a non-stick inner surface is required, and the inscribable surface allows marking for identification. UV stabilization and resistance to chemical agents increase durability in exposed environments, and the material is non-corrosive, infusible and self-extinguishing (except transparent variants).

Suitable for

• Insulating soldered joints and wire splices
• Protecting connectors and terminal ends
• Providing strain relief on cable entries and terminations
• Repairing damaged cable sheaths and coverings
• Identification marking on harnesses and wiring

Key specifications

• Product type: Heat shrink tubing, thin wall
• Length: 100 cm (single piece)
• Wall type: Thin wall, non-adhesive
• Material properties: High flexibility, high tensile strength, thermally stable (resistant to cold flow)
• Electrical properties: Superior electrical insulation characteristics
• Environmental resistance: Stabilized against UV rays; resistant to chemical agents; non-corrosive
• Fire behavior: Self-extinguishing (transparent version excluded)
• Surface: Inscribable for marking

How to use

Select a length of CellPack 144410 heat shrink tubing that covers the area to be insulated with a small overlap on each side. Slide the tubing over the wire, splice or connector before joining if possible. Apply even heat using a heat gun, hot air tool or controlled flame while rotating the assembly to ensure uniform shrinkage. Heat until the tubing conforms closely to the component and no gaps remain; avoid overheating to maintain material properties.

Recommendations

For reliable results, use a regulated heat gun and work in a ventilated area. When insulating soldered joints, ensure the joint is mechanically secure before shrinking the tubing. If a sealed, adhesive-lined termination is required, choose an adhesive-lined variant; the CellPack 144410 is non-adhesive. Keep spare lengths for complex harnesses, and request other lengths from the supplier if a continuous spool is preferred.