Unidad de estado sólido PATRIOT P410 2 TB M.2 NVMe, 2000 GB, factor de forma M.2

PATRIOT P410 2 TB M.2 NVMe is a compact solid state drive designed for laptops, desktops and compact systems. With 2000 GB capacity and an M.2 form factor, this SSD uses a PCIe NVMe interface and delivers high sequential performance—up to 5 Gbit/s listed transfer rate (PCIe Gen4 x4, sequential reads up to 5000 MB/s and writes up to 4500 MB/s as specified by the manufacturer). The drive is lightweight (approximately 0.011 kg) and intended to accelerate OS boot times, application launches and general file access while fitting into space-constrained devices.

Advantages

The P410 offers fast sequential read and write throughput that reduces wait times for system startup and program loading. Its M.2 2280 single-sided format and low weight simplify installation in laptops and small form-factor desktops. An advanced caching architecture and support for host memory buffer improve sustained write performance and power efficiency, helping to reduce heat and extend battery life in portable systems. The product is covered by a multi-year manufacturer warranty.

Suitable for

• Upgrading laptop storage to improve boot and application load times
• Installing in compact desktops and mini PCs where space is limited
• Storage expansion for everyday productivity, media access and light content creation
• Replacing older SATA drives for noticeably faster responsiveness

Key specifications

• Capacity: 2000 GB
• Form factor: M.2 (single-sided 2280 compatible)
• Interface: PCIe NVMe (PCIe Gen4 x4 performance)
• Sequential read speed: up to 5000 MB/s (manufacturer specified)
• Sequential write speed: up to 4500 MB/s (manufacturer specified)
• Weight: approximately 0.011 kg
• Operating temperature range: 0°C to 70°C
• Total Bytes Written (endurance): 1280 TBW

How to use

Power down and unplug the host device before installation. Locate an available M.2 slot on the motherboard that supports NVMe drives, remove any securing screw, insert the M.2 module at an angle and press down to secure it with the screw. Reassemble the device, power on and enter the system BIOS or firmware to confirm the drive is detected. Initialize, partition and format the drive within your operating system as required, then install your OS or migrate data from an existing drive using appropriate cloning software if needed.

Recommendations

Use the PATRIOT P410 in hosts that support PCIe NVMe M.2 drives and PCIe Gen4 where possible to achieve peak sequential performance. For portable devices, enable power-management features in the OS to maximize battery life. Ensure adequate airflow or cooling in compact systems to maintain sustained performance under heavy workloads, and perform regular backups to protect important data.