Conector hembra Victron 16 A/230 V (2p/3w) para clavija de aparato empotrable (SHP301604000)

The demountable MP16-110 coupling socket is used with the MP16-10 built-in appliance plug.

The demountable coupling socket MP16-110 from Victron Energy (MPN SHP301604000) is intended for use with the MP16-10 built-in appliance plug. The cable size to be used depends on the current.

• Features
• Safety regulations and measures
• The electrical installation must be switched off during installation.

Install the shore power inlet according to the installation instructions.

• Use cables with appropriate cross-sections.

Connections and safety precautions must be carried out in accordance with local regulations.

Proceed as follows to attach the plug to the cable

Unscrew the plug and slide the housing onto the cable. The grommet can be cut to size.

Strip the cable. Make sure the cable ends are clean and not corroded. If necessary, cut the cable back until clean wire is visible. Do not solder the cable ends!

Insert the cables into the correct, colour-coded terminal openings on the back of the inlet. Tighten the terminal screws to a torque. Make sure no cable insulation is under a terminal.

• Tighten the strain relief.

Slide the housing over the plug. If necessary, apply a small amount of soap to the cable to make the plastic protection slide easily. Tighten the mounting screws firmly.

• 1x Victron coupling socket 16A (SHP301604000)