16 GB G.Skill SO-DIMM 1600 (2x 8 GB) kit dual (F3-1600C11D-16GSL)

The G.SKILL Memory Module DDR3 16GB 1600MHz (2 x 8GB) is a 204-pin SO-DIMM kit designed for laptops, offering dual-channel 16 GB capacity with a 1600 MHz clock and CAS latency 11. With a low operating voltage of 1.35V, this DDR3 SO-DIMM aims to deliver stable multitasking performance while reducing power consumption and heat generation.

Advantages

The low voltage design (1.35V) reduces power draw and operating temperature, which can help extend laptop battery life and improve thermal stability. The kit is validated for quality and stability through G.SKILL burn-in tests. It is also backward-compatible with systems that expect DDR3 1.5V SO-DIMM modules, providing broader system compatibility without requiring higher voltage.

Suitable for

• Upgrading laptop memory to 16 GB for better multitasking
• Gaming on laptops that accept SO-DIMM DDR3 modules
• Multimedia editing and content creation on portable machines
• General performance boost for programming, web browsing and office work

Key specifications

• Brand: G.SKILL
• Model / MPN: F3-1600C11D-16GSL
• Capacity: 16 GB (2 x 8 GB)
• Type: DDR3 SO-DIMM, 204-pin
• Speed: 1600 MHz
• CAS Latency: CL11
• Voltage: 1.35V (compatible with 1.5V DDR3 systems)
• EAN: 4711148591751

How to use

Power off the laptop, disconnect the power source and remove the battery if applicable. Open the memory compartment or back cover according to your laptop manufacturer’s instructions. Ground yourself to avoid static discharge, then remove existing SO-DIMM modules if necessary. Align the notch of each G.SKILL SO-DIMM with the slot and press down gently until the side clips engage. Replace the cover and battery, reconnect power and boot the system. Verify that the BIOS/UEFI and operating system recognize the full 16 GB capacity and the expected frequency.

Recommendations

Install modules as matched pairs in the correct slots to enable dual-channel mode. If your system specifies only DDR3 1.5V, confirm compatibility in the BIOS/UEFI; this 1.35V kit is designed to work in many 1.5V-supporting systems but consulting the laptop manual or vendor support is advised for edge cases. Ensure proper cooling and avoid heavy thermal throttling by keeping ventilation unobstructed.