64GB Mushkin SO-DIMM 3200 (2x 32 GB) kit dual (negro, MRA4S320NNNF32GX2, Redline)

Mushkin DDR4 64GB 3200MHz (2x32GB) is a SO-DIMM memory kit designed for laptops and compact systems. The 64 GB capacity in a 2 x 32 GB configuration and 3200 MHz clock speed provide increased multitasking headroom and responsiveness. The modules use DDR4 technology with a CAS latency of 22 and operate at 1.2 V. Each module is hand-tested and tuned to deliver stable operation at the specified timings and frequency.

Advantages

The memory kit is engineered for high performance and reliability: hand-tested modules, enhanced timings and frequency settings for improved real-world performance, and lifetime warranty coverage. The SO-DIMM form factor allows upgrades in laptops and small form-factor PCs while maintaining low voltage (1.2 V) operation for efficient power use.

Suitable for (tasks / use cases)

• Upgrading laptop memory for multitasking and professional workloads
• Compact and small form-factor systems that require SO-DIMM modules
• Gaming laptops and mobile workstations seeking higher memory capacity and responsiveness
• Content creation and software development that benefit from more RAM

Key specifications

• Total capacity: 64 GB (2 × 32 GB)
• Memory type: DDR4
• Form factor: 260-pin SO-DIMM
• Clock speed: 3200 MHz
• CAS latency: 22
• Operating voltage: 1.2 V
• Hand-tested modules with factory-tuned timings and frequency

How to use

Power off the laptop or small form-factor PC and remove the battery if applicable. Open the memory compartment according to the device manufacturer’s instructions. Align the 260-pin SO-DIMM module with the slot notch and insert at a slight angle, then press down until the retaining clips engage. Reassemble the device and power it on. Verify the system recognizes the full 64 GB and the expected frequency in BIOS/UEFI or the operating system. For optimal results, install both modules in the appropriate paired slots to enable dual-channel operation if supported by the system.

Recommendations

Install memory modules in matched pairs and consult your laptop or motherboard manual for compatible slot configurations. Update BIOS/UEFI to the latest version if necessary to ensure proper recognition of 3200 MHz operation. Handle modules by the edges and observe electrostatic discharge (ESD) precautions during installation.