Base de montaje PRESBET para DEA LIVI, SOMFY ELIXO, BFT DEIMOS, ROGER M30 – altura ajustable 10,5–16 cm, galvanizada, RAL7016

PRESBET mounting base designed for gate operators such as DEA LIVI, SOMFY ELIXO, BFT DEIMOS and ROGER M30 offers an adjustable-height solution for secure attachment of operator units to posts or foundations. The base is zinc plated and finished in RAL7016, providing corrosion resistance and a uniform appearance suitable for outdoor gate automation installations. Height adjustability from 10.5 to 16 cm allows installers to align the operator precisely with gate geometry and to accommodate variations in site conditions.

Advantages

The adjustable design simplifies on-site alignment and reduces the need for shims or additional brackets. Zinc plating combined with a RAL7016 finish improves resistance to rust and weathering while maintaining a consistent look with typical gate hardware. The base is engineered to provide stable support for the operator unit, minimizing vibration and maintaining reliable mechanical engagement over time.

Suitable for

• Mounting DEA LIVI gate operators
• Installing SOMFY ELIXO automation units
• Fixing BFT DEIMOS operator systems
• Attaching ROGER M30 gate motors
• Outdoor residential and light-commercial gate automation

Key specifications

• Adjustable height: 10.5–16 cm
• Material finish: zinc plated for corrosion protection
• Color: RAL7016 (anthracite grey)
• Compatibility: designed to accept DEA LIVI, SOMFY ELIXO, BFT DEIMOS and ROGER M30 operator units
• Intended mounting: post or foundation attachment for swing gate operators

How to use

Position the mounting base on the prepared post or foundation and set the height between 10.5 and 16 cm according to gate geometry and operator requirements. Secure the base using appropriate anchors or bolts for the substrate type, ensuring the base is level and aligned with the gate pivot. Attach the operator unit to the base following the operator manufacturer's mounting instructions, check mechanical engagement and clearances, then tighten fastenings to the recommended torque values.

Recommendations

Use corrosion-resistant fasteners and follow the gate operator manufacturer’s installation guidelines. Verify alignment and clearance during initial setup and retorque mounting hardware after a short period of operation. For coastal or highly corrosive environments consider additional protective coatings or more frequent inspections.