Cable óptico activo CBO SFP28-AOC-5M 5 m SFP28 Twinax compatible

Active Optical Cable CBO SFP28-AOC-5M is a 5 m SFP28-compatible pre-terminated fiber link designed for 25Gbps server, switch and storage interconnects. The integrated SFP28 connectors remove the need for separate transceivers, offering a compact, low-latency connection for short to medium runs in data centres and high-density network racks. The BlueOptics AOC provides a factory-terminated solution that simplifies cabling and reduces the number of transceiver ports required while preserving signal integrity over a 5 metre span.

Advantages

The SFP28-AOC-5M delivers consistent 25 Gigabit performance with reduced electrical noise and lower heat compared with active copper alternatives. As a plug-and-play assembly it eliminates manual fibre termination and transceiver installation, reducing deployment time and potential compatibility issues. Its integrated SFP28 form factor keeps rack cabling neat and lowers physical connector count on switches and servers. The optical medium extends reliable high-speed links across short to medium distances with minimal latency and predictable signal behaviour.

Suitable for

• Top-of-rack and end-of-row 25GbE switch-to-server connections
• Inter-switch links inside data centre racks
• Storage array connections requiring 25Gbps bandwidth
• High-density virtualised server environments with limited transceiver slots

Key specifications

• Connector type: SFP28 integrated on both ends
• Data rate: 25 Gbps duplex
• Cable length: 5 metres
• Medium: active optical fibre
• Latency: low, suitable for latency-sensitive applications
• Operating environment: designed for indoor/data-centre use

How to use

Install the Active Optical Cable by inserting each integrated SFP28 connector into the corresponding SFP28 port on your switch, server or storage device until the latch engages. No separate transceivers or fibre termination are required. Ensure both ends are fully seated and that the host devices are powered and configured for 25GbE operation. Verify link status through the device management interface and monitor for correct speed and signal integrity. For moves or reconfiguration, unplug by depressing the connector latch and pulling straight out to avoid damaging the port.

Recommendations

For optimal performance, route the cable away from high-heat sources and avoid tight bends; maintain the manufacturer’s minimum bend radius. Use the 5 m AOC for intra-rack or short cross-rack connections. Confirm device compatibility with SFP28 AOC modules and ensure firmware or driver support where required.