Transceptor CBO SFP-10G-BX-U fibra óptica 10G 1310nm SFP+ fibra única

CBO SFP-10G-BX-U Fiber Optic 10G 1310nm SFP+ single-fiber is a hot-pluggable 10 Gigabit SFP+ transceiver module designed for single-fiber bi-directional links. The module transmits at 1310 nm and provides a compact form factor for use in compatible 10G ports on switches and routers. It is intended for deployment in backbone, campus and metro environments where stable, high-speed optical connectivity over a single fiber strand is required.

Advantages

The transceiver supports 10G data rates with a bi-directional single-fiber design that reduces cabling requirements and simplifies fiber management. Its SFP+ form factor allows hot-pluggable installation without powering down equipment, enabling minimal downtime during upgrades or replacements. The optical interface and transmitter wavelength are optimized for long-distance links when used with appropriate single-mode fiber and compatible receiving modules.

Suitable for

• Connecting 10G switches and routers over single-fiber bi-di links
• Backbone and campus fiber links requiring high throughput
• Metro network segments where fiber resources are limited
• Upgrades to existing 10G ports without changing physical chassis

Key specifications

• Data rate: 10 Gigabit Ethernet
• Optical transmit wavelength: 1310 nm
• Interface: SFP+ (hot-pluggable)
• Fiber type: single-mode fiber (single-fiber bi-directional)
• Connector type: single-fiber optical connector (bi-di configuration)

How to use

Insert the SFP+ transceiver into a compatible 10G SFP+ port on the switch or router until it clicks into place. Connect the single fiber cable to the module’s optical connector, ensuring the correct orientation for the bi-directional link and that the paired module at the remote end is configured for the complementary transmit/receive wavelengths. After insertion, verify link status via the device’s port indicators or management interface and monitor for stable operation. For removal, depress the latch and gently pull the module straight out to avoid damage.

Recommendations

Use single-mode fiber rated for the intended link distance and verify compatibility with the remote transceiver to ensure correct transmit/receive wavelength pairing. Avoid bending the fiber beyond specified minimum bend radius, keep connectors clean and use dust caps when the transceiver is not connected. Perform link tests after installation to confirm expected throughput and signal integrity.