Transceptor CBO SFP-10G-ERBD-U fibra óptica 10G monomodo SFP+

The CBO Transceiver SFP-10G-ERBD-U Fiber Optic 10G Single‑Mode SFP+ is a compact hot-pluggable optical module designed to deliver 10 Gigabit Ethernet over single‑mode fiber. Intended for installation in compatible SFP+ ports of switches, routers and servers, this BlueOptics transceiver supports long-reach links and is suitable for backbone and campus connections where stable 10G connectivity is required. The module's form factor and electrical compatibility make it suitable for network upgrades and expansion without major hardware changes.

Advantages

This single‑mode SFP+ transceiver provides consistent 10G data transmission over extended distances, enabling reliable long‑reach optical links. Its hot‑pluggable design simplifies installation and replacement while minimizing downtime. The module is built to industry form-factor and signaling standards to ensure interoperability with a wide range of networking equipment that accepts SFP+ optical modules.

Suitable for

• Long‑reach 10 Gigabit Ethernet links between buildings or data centers
• Upgrading switch and router uplinks to 10G over single‑mode fiber
• High‑capacity server connections and storage networking
• Backbone and aggregation layer links in enterprise or carrier networks

Key specifications

• Data rate: 10 Gigabits per second
• Fiber type: single‑mode fiber (SMF)
• Form factor: SFP+ (hot‑pluggable)
• Optical interface: duplex LC connector
• Transmission reach: designed for long‑reach single‑mode links
• Compatibility: suitable for devices with SFP+ optical ports supporting 10G

How to use

Insert the SFP+ transceiver into an available compatible SFP+ port until it latches securely, then connect single‑mode duplex LC fiber patch cords to the module's optical interfaces, observing correct transmit/receive orientation. After physical installation, verify link status on the connected switch, router or server and configure interface settings as required by your networking equipment. For hot‑swap situations, remove or insert the module while the host supports hot‑pluggable operation and take appropriate electrostatic discharge (ESD) precautions.

Recommendations

Use single‑mode duplex LC patch cords of appropriate quality and ensure fiber connectors are clean before mating. Confirm that the target device supports SFP+ optics and 10G operation; consult equipment documentation for any vendor compatibility notes. Handle the transceiver using ESD protection and store it with dust caps when not in use.