Transceptor de fibra óptica CBO SFP-1G-ZX — 1 Gbit/s, monomodo, hasta 80 km

CBO SFP-1G-ZX is a fiber optic SFP transceiver module that supports a 1 Gbps data rate over single‑mode fiber for links up to 80 km. With a standard SFP form factor and hot‑pluggable design, the module is intended for insertion into compatible switches, routers and media converters to extend WAN, metro and enterprise network connections without interrupting device operation.

Advantages

The transceiver provides long‑reach single‑mode connectivity with a nominal range of up to 80 km while maintaining a compact SFP form factor. Hot‑plug capability allows module replacement or addition without powering down the host device. Compatible with standard SFP slots, the module simplifies inventory and deployment for mixed-vendor networks. It supports a 1 Gbps data rate suitable for uplink, aggregation and long-distance access links.

Suitable for

• Long‑distance single‑mode uplinks between switches and routers
• WAN and metro network links requiring up to 80 km reach
• Enterprise campus interconnects and remote site connections
• Replacement or upgrade of existing SFP-based fiber ports

Key specifications

• Data rate: 1 Gbps (full duplex)
• Fiber type: single‑mode
• Maximum link distance: up to 80 km
• Form factor: SFP (hot‑pluggable)
• Optical wavelength: typical long‑reach wavelength for single‑mode operation
• Connector type: LC duplex compatible

How to use

Insert the SFP transceiver into a compatible SFP slot on a switch, router or media converter until it clicks into place. Connect single‑mode fiber using an LC duplex connector, observing correct transmit/receive orientation. After insertion, verify link status and speed on the host device; most systems detect the module automatically. To remove the module, disengage any retention latch and gently pull the transceiver from the slot. Handle the optical interfaces with dust caps in place when not connected and avoid touching ferrules.

Recommendations

Use single‑mode fiber rated for long‑reach transmission and ensure fiber endfaces are clean before connection. Verify host device compatibility with SFP modules and confirm supported wavelengths and link budgets for 80 km links. Store unused modules in anti‑static packaging and protect optical ports from dust and moisture.