Transceptor de fibra óptica SFP CBO SFP-1G-EX – 1 Gbit/s monomodo, 1G

CBO SFP-1G-EX is an SFP fiber optic transceiver that supports 1 Gbps data transmission over single‑mode fiber. It is intended for installation in compatible SFP ports on switches, routers and media converters to provide optical uplink or backbone connectivity. The module offers a compact, hot‑pluggable interface for extending network links over long distances where 1G optical connectivity is required.

Advantages

The transceiver provides a stable 1 Gbps link on single‑mode fiber with a standardized SFP form factor, ensuring compatibility with many networking devices that accept SFP modules. Its plug‑and‑play design simplifies deployment without requiring special configuration. The compact module conserves space in equipment chassis and supports long‑reach connections to extend network topology across buildings or sites.

Suitable for

• Backbone and distribution uplinks between network switches
• Long‑reach connections between buildings or data closets
• Optical uplinks for routers and media converters
• Replacement or upgrade of 1G SFP ports in managed and unmanaged equipment

Key specifications

• Data rate: 1 Gbps (Gigabit Ethernet)
• Fiber type: single‑mode
• Form factor: SFP (small form‑factor pluggable), hot‑pluggable
• Interface: optical fiber connector (LC compatible)
• Typical application: uplink, backbone and long‑reach links
• Operating environment: designed for standard network equipment ambient conditions

How to use

Install the CBO SFP-1G-EX into a compatible SFP slot on your switch, router or media converter while the device is powered on or off, as the module is hot‑pluggable. Connect the single‑mode optical fiber cable to the module’s optical port using the appropriate LC connector and ensure the other end is connected to the corresponding transceiver or patch panel. Verify link status via the host device’s LEDs or management interface and configure the port settings on the network device if necessary for speed or duplex, though most equipment will negotiate the 1 Gbps link automatically.

Recommendations

Use single‑mode fiber with appropriate attenuation and link budget for the intended distance. Keep fiber connectors clean and protected when inserting or removing the transceiver to maintain signal quality. Confirm compatibility with the host device’s SFP ports and supported optical specifications before installation.