Transceptor SFP+ CBO para Palo Alto Networks SFP-10G-BX-U 10G fibra óptica módulo bidireccional de fibra única

The SFP+ transceiver CBO for Palo Alto Networks SFP-10G-BX-U is a 10 Gbps single‑fiber bidirectional (BX) module compatible with devices that accept SFP+ ports. It supports 10G connectivity over single‑mode fiber, enabling long‑distance uplinks and links in switches, routers and security appliances. The module is hot‑swappable and designed for straightforward replacement or upgrade of existing 10G fiber interfaces, providing a compact form factor suitable for dense networking environments.

Advantages

This SFP+ transceiver offers 10 Gbps throughput over a single fiber strand using bidirectional transmission, reducing fiber cabling requirements. Compatibility with devices that accept the Palo Alto Networks SFP-10G-BX-U form factor allows easy integration into existing setups. The hot‑swappable design enables maintenance or upgrades without powering down the host, while the compact SFP+ format preserves port density in network equipment.

Suitable for

• 10 Gbps uplinks between switches and routers over single‑mode fiber
• Long‑distance point‑to‑point fiber links requiring bidirectional operation
• Security appliances and firewalls with SFP+ ports that accept compatible transceivers
• Data center and enterprise aggregation where fiber count reduction is desired

Key specifications

• Interface: SFP+ hot‑pluggable form factor
• Data rate: 10 Gbps
• Fiber type: single‑mode fiber (SMF)
• Transmission: bidirectional (BX) over a single fiber strand
• Typical use: uplinks and long‑distance links

How to use

Insert the SFP+ transceiver into an available SFP+ slot of a compatible switch, router or security appliance until it clicks into place. Connect a matching single‑mode fiber cable with appropriate connectors to the transceiver. If required by the host, install complementary BX transceiver or configure link parameters in the network device. The module supports hot‑swap; remove by depressing the release latch and gently pulling the module out when maintenance or replacement is needed.

Recommendations

Verify device compatibility with the Palo Alto Networks SFP-10G-BX-U form factor and ensure the opposite link end uses the correct complementary BX transceiver. Use single‑mode fiber of appropriate quality and follow ESD safety procedures when handling the transceiver. For optimal performance, confirm link configurations (speed/duplex) and monitor link status after installation.