Transceptor SFP+ CBO para Palo Alto Networks SFP-10G-ZR 10G 80km

SFP+ transceiver CBO for Palo Alto Networks SFP-10G-ZR 10G 80km is a 10 Gbps single-mode fiber optical module designed for long-distance network links. Branded BlueOptics (CBO), this SFP+ module provides an optical reach of up to 80 km over single-mode fiber and is intended for insertion into compatible 10G SFP+ ports. It is suitable for data center interconnects, campus backbone links, and other network aggregation points where extended reach and high throughput are required.

Advantages

The transceiver offers a standardized SFP+ form factor for broad compatibility with equipment that supports the Palo Alto Networks SFP-10G-ZR profile, enabling 10 Gbps full-duplex connectivity over single-mode fiber. Its extended optical reach of up to 80 km reduces the need for intermediate amplification or regeneration in many metropolitan and campus scenarios. The module is designed for low latency and consistent throughput, supporting high-bandwidth applications and long-haul fiber links while maintaining the physical and electrical characteristics expected of SFP+ optics.

Suitable for

• Data center interconnects between sites up to 80 km apart
• Campus and metropolitan backbone links
• Network aggregation and high-capacity uplinks
• Long-distance fiber connections requiring 10 Gbps throughput

Key specifications

• Form factor: SFP+ (10 Gigabit)
• Data rate: 10 Gbps
• Fiber type: single-mode fiber (SMF)
• Maximum optical reach: up to 80 km
• Wavelength: typical single-channel long-reach wavelength (ZR-class)
• Duplex mode: full duplex
• Connector type: LC duplex
• Typical application: long-haul and metro links, data center links

How to use

Install the SFP+ transceiver into a compatible 10G SFP+ port on network equipment that accepts modules with the Palo Alto Networks SFP-10G-ZR profile. Ensure both ends of the link use single-mode fiber with LC duplex connectors and that fiber polarity is correct. After insertion, confirm link status in the device management interface and verify optical levels and SFP diagnostics if available. Handle the module carefully, avoiding contact with the fiber end faces and protecting unused ports with dust caps.

Recommendations

For reliable long-distance operation, use single-mode fiber compliant with ITU-T specifications, verify end-to-end attenuation to ensure margin for the 80 km reach, and perform optical power and link tests after installation. Use compatible modules at both ends and monitor transceiver diagnostics for temperature and signal levels to maintain stable 10 Gbps links.