Transceptor SFP+ CBO SFP-10G-SR-CN-BO 10 Gbit/s 300 m 850 nm

CBO SFP-10G-SR-CN-BO is an SFP+ optical transceiver module engineered for short-range 10 Gigabit Ethernet links. It supports a 10 Gbit/s data rate over multimode fiber at an 850 nm wavelength and reaches distances up to 300 m. The module follows the standardized SFP+ form factor and offers hot-pluggable installation for straightforward deployment in data center switches, server NICs and other compatible network equipment.

Advantages

The SFP+ transceiver delivers reliable 10 Gbit/s performance with low power consumption in a compact, industry-standard housing. Hot-pluggable capability allows replacement or upgrade without powering down equipment. Compatibility with multimode fiber and common 850 nm optics simplifies integration into existing short-range fibre links used in campus networks and data centers.

Suitable for

• Short-range 10 Gigabit Ethernet links within data centers
• Interconnects between switches, routers and server NICs
• Multimode fiber backbone and aggregation links up to 300 m
• Hot-swap upgrades and maintenance in active rack systems

Key specifications

• Data rate: 10 Gbit/s
• Wavelength: 850 nm
• Maximum reach over multimode fiber: 300 m
• Form factor: SFP+
• Connector type: Duplex LC
• Application: Short-range 10 Gigabit Ethernet and data center interconnects
• Hot-pluggable: Yes

How to use

Install the SFP+ transceiver into the SFP+ port of a compatible switch, router or network interface card until it clicks into place. Connect duplex multimode fiber using LC connectors matched to the module. Monitor link status through the host device to verify synchronization and negotiated speed. For removal, release the module latch and pull it straight out while observing electrostatic discharge precautions.

Recommendations

Use multimode fiber of the appropriate grade (such as OM3/OM4) and maintain clean LC connector end faces to ensure optimal signal performance. Verify compatibility with the host device's supported transceiver types and firmware, and follow manufacturer guidelines for operating temperature and handling to maximize module lifespan.