Módulo transceptor SFP BlueOptics BO35J15640DIN 10000 Mbit/s

The BlueOptics BO35J15640DIN is an SFP+ fiber optic transceiver module designed for 10 Gbit/s network links. It has a compact SFP form factor and a silver housing, providing hot-pluggable connectivity for compatible switches, routers and network interface cards. The module is intended for high-speed data transmission over optical fiber and is manufactured to meet CE, FCC and RoHS compliance. With a rated maximum data transfer rate of 10000 Mbit/s and an MTBF of 3,000,000 hours, the module supports reliable operation in data center and enterprise network environments.

Advantages

The transceiver offers a standardized SFP+ interface for straightforward installation in compatible ports and supports 10 Gbit/s links for demanding bandwidth needs. Its compact form factor and low weight simplify handling and reduce physical load on equipment. Compliance with common regulatory standards ensures interoperability and environmental conformity. The high MTBF rating indicates long-term reliability and reduced need for frequent replacement.

Suitable for

Key specifications

How to use

Install the BlueOptics BO35J15640DIN by inserting the module into a compatible SFP+ port until it clicks into place; ensure the host device is powered according to the vendor's instructions. Connect the appropriate optical fiber cable to the module's connector, observing correct polarity and connector type for the fiber used. Configure link settings on the network device as required for 10 Gbit/s operation and verify link status through the device management interface. For hot-plug operations, follow the equipment manufacturer's procedures to avoid transient disruptions.

Recommendations

Use quality multimode or singlemode fiber and matching connectors compatible with the transceiver and the network design. Verify firmware and driver compatibility of the host device, and operate the module within the environmental limits specified by the equipment vendor. Handle the transceiver with care to avoid contamination of optical interfaces; cap unused ports when not connected.