BlueOptics UF-SM-10G-S-1330-20-BO Módulo transceptor de red de fibra óptica 10000 Mbit/s SFP+

The BlueOptics UF-SM-10G-S-1330-20-BO network transceiver module is a single-mode SFP+ optical transceiver designed for 10G data links. It supports a maximum data transfer rate of 10000 Mbit/s, is supplied from a 3.3 V input, and is housed in a compact metal enclosure with a silver finish. With LC simplex connectivity and a lightweight 20 g body, this module is intended for deployment in networking equipment that accepts SFP+ form-factor transceivers and for point-to-point single-mode fiber links up to typical long-reach distances.

Advantages

The transceiver implements the SFP+ interface standard and complies with industry MSA mechanical dimensions, providing straightforward interoperability with equipment that supports 10G SFP+ modules. Its metal housing offers mechanical robustness and electromagnetic shielding while keeping a low weight for easy handling and installation. The design supports bi-directional optical transmission on a single fiber using separate wavelengths for transmit and receive, enabling efficient single-mode fiber links. The module also supports digital diagnostics monitoring (DDM/DOM) when used in compatible host hardware, allowing remote reading of operating parameters.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP+ module into an empty SFP+ slot of a compatible switch, router or storage device according to the host device’s instructions. Connect an LC simplex single-mode fiber patch cord between this transceiver and the remote transceiver or patch panel, observing proper transmitter-to-receiver polarity for bi-directional links. Ensure the host device supports the required transmission protocol and any needed DDM/DOM monitoring features. After insertion, verify link negotiation and signal presence through the host device’s interface and perform optical power checks if required.

Recommendations

Use certified single-mode LC simplex patch cords and ensure correct wavelength pairing for bi-directional (BX) operation. Confirm that the receiving equipment supports SFP+ 10G modules and DDM/DOM if diagnostic monitoring is required. Handle the module by the housing, keep dust caps on connector interfaces when not in use, and follow ESD precautions during installation to maintain reliability and service life.