Cable de alimentación EFB Elektronik EK601SW.3 negro 3 m

The EFB Elektronik EK601SW.3 Black 3 m is a mains power cable designed for reliable connection between equipment and power distribution units or wall outlets. One end of the cable has an IEC C14 male inlet and the other end a matching IEC C13 female connector. The cable supports up to 250 V and a current rating of 10 A, and is supplied in a 3 metre length to provide extended reach while maintaining a compact, flexible form factor suitable for server racks, workstations and general IT equipment.

Advantages

This power cable offers standardized IEC connectors (C14 to C13) that ensure compatibility with a wide range of electronic devices and power supplies. The 3 m length reduces the need for extension adapters and allows more flexible positioning of equipment. With a 10 A current rating and 250 V voltage capacity, the cable meets common mains requirements for office and home electronic devices. The black outer sheath provides a neutral appearance that integrates into professional environments.

Suitable for

• Connecting desktop PCs, monitors and printers to power outlets or PDUs
• Powering servers and network equipment in racks with IEC power inlets
• Home office setups where additional reach is required
• Temporary power connections during maintenance or equipment swaps

Key specifications

• Connector 1: IEC C14 (male) inlet
• Connector 2: IEC C13 (female) coupler
• Cable length: 3 m
• Rated voltage: 250 V
• Rated current: 10 A
• Colour: Black

How to use

Insert the IEC C14 end into the power source or PDU inlet and connect the IEC C13 end to the device's power input. Ensure the cable is fully seated in both connectors to maintain a secure electrical connection. Route the cable to avoid sharp bends, pinching or contact with heat sources. Verify that the connected device's voltage and current requirements do not exceed the cable's 250 V / 10 A ratings before use.

Recommendations

Inspect the cable periodically for visible wear, cuts or damage to the insulation and replace it if any defects are found. Avoid using the cable in wet environments or where it could be exposed to mechanical stress beyond normal installation. For installations in professional environments, secure excess cable length and maintain good cable management to reduce strain on connectors and improve airflow around equipment.