Cable de fibra óptica InfiniBand BlueOptics ET7402-AOC-25M-BO QSFP28 25m conector/conector

The BlueOptics ET7402-AOC-25M-BO InfiniBand fibre optic cable 25m QSFP28 Male/Male is a 25-metre active optical cable (AOC) with QSFP28 connectors on both ends. Designed for high-speed data transmission over multimode fiber, this AOC implements the QSFP28 to QSFP28 connection according to MSA standards and supports 100GBASE-SR4 applications. The cable integrates optical transmitter and receiver modules on each end to transfer optical signals and is intended for use in data center and high-performance computing environments where reliable 100 Gbit/s links are required.

Advantages

This 25 m AOC provides a factory-terminated, plug-and-play QSFP28 to QSFP28 solution that eliminates the need for separate transceivers and patch cords, simplifying installation and reducing potential points of failure. Compliance with MSA standards ensures interoperability with equipment that supports QSFP28 and 100GBASE-SR4 interfaces. The male-to-male QSFP28 configuration offers broad compatibility with switches, routers and storage systems that accept QSFP28 AOCs for short-reach 100G connections.

Suitable for

Key specifications

How to use

Install the BlueOptics ET7402-AOC-25M-BO by inserting the QSFP28 connectors into compatible QSFP28 ports on network switches, routers or host devices. Ensure devices are powered off or follow hot-plug guidelines provided by the hardware vendor when plugging in or removing the cable. Verify link status and data rate through the device management interface and confirm compatibility with the host ports' supported protocols such as 100GBASE-SR4. No separate optics or additional patch cords are required.

Recommendations

Use in indoor data center environments with organized cable routing and strain relief; avoid tight bends and exposure to excessive mechanical stress. Confirm equipment compatibility with QSFP28 AOCs and the supported 100G protocol before deployment. For diagnostic or interoperability assurance, test the link under expected load conditions in a controlled environment prior to full production use.