Cable de parcheo helos 205243 conector RJ-45 macho a macho 10 m

Patch cable helos 205243 RJ-45 m to m 10 m is a 10-metre Ethernet patch lead with RJ-45 male connectors on both ends, designed to provide a fixed copper connection between network equipment. It connects switches, routers, patch panels and computers for data transmission over standard Ethernet networks. The cable's length and terminated RJ-45 plugs make it suitable for horizontal and cabinet patching in home, office and small data-room environments.

Advantages

The cable delivers a simple, low-latency copper link that requires no additional termination on site and supports straightforward plug-and-play installation. Its fixed length reduces cable clutter and eases rack and desk management. Built with standard RJ-45 terminations, it is compatible with commonly used Ethernet ports and typical networking hardware. The product's construction provides consistent physical connectivity for stable throughput in short-distance runs.

Suitable for

• Connecting desktop computers to wall outlets or switches
• Patch panel to switch connections in network cabinets
• Linking routers, modems and networked devices
• Temporary or permanent office and home network cabling

Key specifications

• Cable type: Unshielded twisted pair (typical patch cable construction)
• Connector type: RJ-45 male to RJ-45 male
• Length: 10 m
• Conductor: Copper cores (solid or stranded depending on manufacturing)
• Intended use: Ethernet data transmission for local area networks
• Installation: Plug-and-play, no on-site termination required

How to use

Insert each RJ-45 male connector into the Ethernet port of the devices you want to connect, ensuring the clip clicks into place. Use the 10 m length to route between desks, switches and patch panels while avoiding tight bends and sharp kinks. For rack installations, follow standard cable management practices to maintain bend radius and reduce strain on connectors. If replacing an existing cable, power down equipment if recommended by the device manufacturer before disconnecting.

Recommendations

For reliable performance, avoid running the cable parallel and close to high-voltage power lines or large electrical equipment to minimise potential interference. Keep the cable within its specified bend radius and avoid stretching or crushing. For permanent installations in structured cabling, verify desired network category and performance requirements; use appropriate shielded or higher-category cables where specified by the network design.