Carcasa de instalación Rittal AX 6315.450 210×500×500 mm, chapa de acero/aluminio/plástico, gris claro

Rittal AX 6315.450 is an installation enclosure with external dimensions 210×500×500 mm, constructed from sheet steel, aluminium and plastic in light gray. Designed for housing electrical and electronic components, it provides a compact, multi-material cabinet suitable for control panels, junctions and small switchgear installations in industrial and commercial environments. The mixed construction balances mechanical strength and reduced weight while offering a clean, corrosion-resistant surface for indoor applications.

Advantages

The combination of sheet steel, aluminium and plastic gives the enclosure structural rigidity where required and lighter handling where possible, resulting in a versatile unit for varied installation needs. Its light gray finish provides a neutral appearance that integrates into most technical rooms and production areas. The enclosure’s dimensions make it space-efficient for confined areas while allowing organized internal mounting of components and wiring. Built to industry design principles, the cabinet facilitates straightforward access for maintenance and wiring changes.

Suitable for

Key specifications

How to use

Mount the enclosure on a suitable flat surface or framework according to local installation standards and the weight of internal components. Prepare internal mounting plates, DIN rails or back panels as required for the intended equipment layout. Route power and signal cables through designated entry points or knock-outs and secure them with appropriate cable glands or bushings. Ensure components are fixed to internal mounting provisions and that clearances are maintained for heat dissipation and service access. Follow applicable electrical codes when connecting power and protective earth.

Recommendations

For best results, inspect the installation environment for moisture, dust and corrosive agents; use additional sealing, IP-rated glands or protective coatings if required. Plan internal layout to allow ventilation and easy access during maintenance, and verify that mounting hardware and cable entries match the selected components.