Conector BitsPower Artemis Advanced Multi-Link 14 mm Diámetro Exterior Stardust Gold

BitsPower Artemis Advanced Multi-Link connector 14mm final diameter Stardust Gold is a threaded connector for custom PC water-cooling systems. Designed to join soft tubing sections and to integrate with compatible fittings, this 14 mm final-diameter Multi-Link component enables neat routing and secure transitions between loop segments. The Stardust Gold finish provides a metallic appearance while maintaining the physical characteristics required for reliable fluid connections in liquid cooling loops.

Advantages

The connector offers a compact multi-link design that reduces bulk at tubing junctions and supports flexible loop layouts. Threaded interfaces ensure a stable mechanical connection and reduce the risk of accidental disassembly. The 14 mm final diameter is suitable for common soft tubing sizes used in custom loops, and the durable surface finish resists handling wear and maintains consistent contact with fittings. The component is compatible with other BitsPower Multi-Link parts and standard threaded fittings intended for the same diameter range.

Suitable for

• Custom PC water-cooling loops requiring a 14 mm final diameter connector
• Joining sections of soft tubing where a secure threaded transition is needed
• Neat routing of coolant lines in compact or complex loop layouts
• Integration with BitsPower Multi-Link series fittings and compatible threaded components

Key specifications

• Final internal diameter: 14 mm (designed for compatible soft tubing)
• Type: Multi-Link threaded connector for liquid cooling
• Finish: Stardust Gold metallic coating
• Material: metal construction suitable for PC coolant environments
• Connection method: threaded coupling for secure joins

How to use

Install the Multi-Link connector by preparing the soft tubing ends to the appropriate length and sliding the tubing over the connector to reach the 14 mm final diameter seating. Mate the connector with compatible threaded fittings and tighten by hand then with an appropriate tool to the manufacturer’s recommended torque for a watertight seal. Ensure all contact surfaces are clean and free of debris before assembly, and route tubing to avoid sharp bends that could stress the connection. After assembly, pressure-test the loop and inspect all threaded interfaces for leaks.

Recommendations

Use compatible soft tubing designed for a 14 mm final internal diameter and approved coolants for PC water-cooling. When assembling multiple Multi-Link components, maintain alignment and avoid over-tightening to prevent thread damage. Perform an initial leak test outside the main system if possible and recheck connections after the first operating cycle.