Conector RJ45 DeLOCK 86926

The DeLOCK 86926 RJ45 wire connector is a compact male RJ45 connector with a zinc-coloured finish designed for reliable Ethernet terminations. With an outer diameter of 8.5 mm, width of 14.4 mm and depth of 42.2 mm, the connector is intended for direct cable-to-device or extension connections where a durable, metal-finish plug is preferred. Packaged individually in a polybag and manufactured in China, this connector suits repair, installation and prototyping tasks that require a standard RJ45 male termination.

Advantages

The metal-like zinc-coloured housing provides robust mechanical protection and stable contact alignment while remaining lightweight. Compact dimensions allow use in confined installation spaces and behind panels where space is limited. The single-piece retail packaging makes it convenient to keep spares or to supply technicians with individual parts for field work.

Suitable for

• Field repairs and replacement of damaged RJ45 terminations
• Network prototyping and temporary cable extensions
• Use in small enclosures or behind equipment panels with limited clearance

Key specifications

• Connector type: male RJ45
• Finish / colour: zinc-coloured housing
• Outer diameter: 8.5 mm
• Width: 14.4 mm
• Depth: 42.2 mm
• Packaging: individual polybag
• Quantity: sold individually

How to use

Prepare the Ethernet cable by stripping the outer jacket and arranging conductors according to the required wiring standard (T568A or T568B). Insert the wires into the connector until they reach the end stop, then secure the connector according to the assembly method compatible with this male RJ45 type. After assembly, visually inspect the contact alignment and, if available, verify continuity and correct pairing with a cable tester before putting the cable into service.

Recommendations

For reliable long-term performance, avoid excessive bending or pulling at the connector-cable interface and ensure connectors are fully seated in mating ports. Store individual connectors in a dry environment and use a cable tester after installation to confirm signal integrity.